We are turning up a POP with an ADTSE Channelized T1.
All of our other POPs are PRI, but not available at this CO
What happens: 4 seconds of silence and then busy signal
If I set "Trunk Type" to "E&M" I show a connection, but there are no tones and it never drops until
I hang up the phone.
Hardware: HiPerARC 5.2.102
HiPerDSP 3.1.7
HiPerNMC 8.2.7
Config: NMC: defaults with IP/Gateway
ARC: defaults, no config
DSP: defaults, with "Signal Mode" set to "Bit Robbed"
also "Trunk Type" set to "LoopStart" (as per CO instructions)
More info on errors:
ERROR with "TrunkType" = "E & M Type II"
TROUBLE SYMPTOMS:
1.) Rings
2.) Equipment shows incoming call
3.) No Tones
4.) Equipment shows call torn down and then out of service
5.) Line never drops
CPE EQUIPMENT RESULTS:
DS0 Timeslot Status (as a call is coming in): 1.) "Specified DS0 is idle(2)"
2.) "incoming call is
dialing(3)"
3.) "Ds0 call is being
torn down(22)"
4.) "Ds0 is out of
service(24)"
DS0 Service State (as a call is coming in): 1.) "inService(2)"
2.)
"remoteOutOfService(5)"
Disconnect Reasons: "E&M Dial In No TELCO Response"
Reason for Call Failure: "abnormalDisconnect(77)"
