- montgomery_boats - mailman.xmission.com

Re: M_Boats: Cockpit drains
by bownez＠juno.com 18 Feb '17

18 Feb '17

Hey Larry, I should do the same. Can you give me details on part number, length, and where to order please? Thanks pal. Mr. Bones 1976 hull #92 ____________________________________________________________ This Herb Stops Balding Immediately And Restarts Hair Growth Regrow Hair Protocol http://thirdpartyoffers.juno.com/TGL3141/58a795b4e2da415b41f99st02vuc

4 3

Re: M_Boats: Cockpit drains
by bownez＠juno.com 17 Feb '17

17 Feb '17

Last time I inspected the aluminum drain tube in my M17 (1976 model), it was holding up well. But, I feel its only a matter of time..... Bones ____________________________________________________________ Affordable Wireless Plans Set up is easy. Get online in minutes. Starting at only $14.95 per month! www.netzero.net?refcd=nzmem0216

3 2

Monty 17 repaint
by David Grah 17 Feb '17

17 Feb '17

I concur with Larry's suggestion to contact Stan Susman (stanpfa(a)pacbell.net) He advised me with the refinishing of our Montgomery 15, and it went really well. My experience is posted below. Message: 2 Date: Fri, 17 Feb 2017 08:25:15 -0800 From: Larry Yake <larryyake(a)gmail.com> To: For and about Montgomery Sailboats <montgomery_boats(a)mailman.xmission.com> Subject: Re: M_Boats: Monty 17 repaint Message-ID: <CANjZbokPXwueoNaHrXHemZRhXmygvA15KYQK=aiLA2GLhRaymg(a)mail.gmail.com> Content-Type: text/plain; charset=UTF-8 Hey, that's Sean's old boat! Sorry, no advice on painting, other than talk to Stan "Paintboy" Stussman (sp?). He's the expert. That's a great boat you have there. Very fast! We won the Cruiser Challenge in her a few years ago. All she needed back then was some cosmetic attention. Glad to see you're fixing her up. Larry M17 CornDog ----- Forwarded Message ----- From: David Grah <d_b_grah(a)yahoo.com> To: For and About Montgomery Sailboats <montgomery_boats(a)mailman.xmission.com> Sent: Tuesday, June 9, 2015 6:28 PM Subject: Plan to Refinish Montgomery 15 Bottom In case is anyone interested in an update on this project, I thought I'd provide one. First, I'd like to say I appreciate all the input I received on the project, especially from Stan Susman, Interlux representative, and Larry Yake. The input helped make the project a success. The project essentially went as planned except for the following: Instead of 4 by 4 posts I used two 2 by 4's screwed together to make something equivalent to a 4 by 4. This was cheaper but also allowed me to extend one 2 by 4 up next to the ceiling joist and screw it into the joist to keep the joist from twisting. I didn't use cables to hold the boat up but used two loops each side of the boat of 4000 pound strength tubular nylon webbing over the ceiling joists. Because there were no cables I didn't need the plywood squares. I also left out the lateral bracing. I went over the bottom 3 times with Citristip. The first application took most of the paint off but a number of tougher spots required an additional 2 applications. I didn't use acetone to clean the bottom. Instead I used thinner for the paint I used. Based on Stan Susman's recommendation, I used Interlux VC Performance Epoxy for bottom paint. I sail in some pristine lakes and liked the idea of not having biocide in the bottom paint. I put on 4 coats and it looks great! I didn't add a waterline stripe. The bottom looked so good the hull above the waterline looked a little shabby. I was thinking about painting the rest of the hull but ended up talking to Larry Yake and, based on his experience polishing his Corn Dog, elected to polish the hull instead. I used rubbing compound, polishing compound, and non-silicone car wax I had around and, I have to say, it looks great. I took the opportunity to replace the registration numbers on the boat with a decal from Decal Zone at the same time and that made a big improvement as well. The whole process was a lot of work but I have to admit I like looking at the finished product. The boat looks really good! From: David Grah <d_b_grah(a)yahoo.com> Date: April 12, 2015 at 6:07:55 PM PDT To: For and About Montgomery Sailboats <montgomery_boats(a)mailman.xmission.com> Subject: Plan to Refinish Montgomery 15 Bottom Reply-To: David Grah <d_b_grah(a)yahoo.com> I'm planning to refinish the bottom of my Montgomery 15 soon and have no experience doing such a thing. I wondered if the group had any comments or suggestions on my planned approach. The boat has several coats of blue ablative bottom paint on it now. They look bad. They are faded and the upper edge of the bottom pain doesn't follow the waterline very well on the starboard side.The boat probably won't be in the water for more than a week at a time for as long as I own it and is usually in fresh water when it is in the water. The hull is white with a blue stripe at the top. I plan to mount 4 - 4 inch by 4 inch posts, 8 foot long, in my garage. The bottoms of the posts will rest on the garage slab and the tops will be bolted or screwed to the joists in the garage. I will brace the joists with diagonal 2 inch by 4 inch to the garage walls (these 2 by 4's are along the bottom of the joists to the plate at the top of the wall). The posts will support the boat and the joists will keep the posts vertical. If things go right there will be very little load on the joists. I'll nail 3/4 inch plywood squares to the tops of the posts and cut groves in the edges to run 1/8 inch cables. I'll move the boat on the trailer into the garage and jack the trailer up a few inches and put it on blocks. I will attach 1/8 inch cables to the back unused holes where the shrouds attach at the edge of the boat and to the cleats on either side at the stern of the boat and loop the cables over the tops of the posts and clamp them.Then I would lower and remove the trailer. When working on the boat, I would place "kickers" under the lip at the hull to deck joint on the side I am working on to lessen the changes that the boat would roll toward me if it came down for some reason. I would also put blocks under the keel. I would use Citristrip stripping gel to remove most of the bottom paint. I have tested it after it was recommended in this group and found it works well. Depending how hard I scrape it can take off some of the gel coat under the bottom paint as well. I'd wipe the bottom with paint thinner and sand it with 60 grit sandpaper to remove most of the remaining blue bottom paint residue. I'd wipe it down with acetone and then sand again with 220 grit sandpaper, probably wet, and wipe with acetone again. I think I will be left with white gel coat over the bottom stained slightly blue. I'd brush on two coats of off-white Interlux Brightside one-part paint up to about 1/4 inch above the top of the old bottom paint and then add a two coat red stripe about 4 inches wide to cover the uneven top of the current bottom paint on the starboard side. I figure the new Interlux won't match the gelcoat so need something to cover this transition. The edge of where the current bottom paint is would always be within the red strip by at least an inch. I'd put the trailer back under the boat and jack it up to take the weight of the posts and the cables, then lower the trailer and take the boat out of the garage and hopefully be done. Does this seem workable? Anything I should plan to do differently? Thanks! David GrahBishop CaliforniaMontgomery 15 - Sky

1 0

Monty 17 repaint
by Jon Barber 17 Feb '17

17 Feb '17

I have a 1973 Monty 17 #44. The hull has been sanded. I am in need of advice on how to proceed with topside painting and bottom painting. Any experience with methods and materials appreciated! With what I have read online and elsewhere in am totally confused. Thanks Jon Barber, Modesto, CA

5 6

boom vang for M15
by mrh219＠yahoo.com 14 Feb '17

14 Feb '17

Anyone have a suggested list of parts for a boom vang for an M15? Mike HettlerM15 Annebonny

1 0

Re: M_Boats: MSOG Photo Site
by ronaldwmcneil 13 Feb '17

13 Feb '17

Gerry, can you possibly let me know my login ID "again" and reset my password. I got it the first time while I was on vacation, then lost it before getting home. Thanks,Ron McNeil M17 / #675 / Jackpot Sent from my Verizon, Samsung Galaxy smartphone -------- Original message --------From: Gerald Wyatt <wyattgs(a)gmail.com> Date: 2/13/17 10:05 PM (GMT-07:00) To: For and about Montgomery Sailboats <montgomery_boats(a)mailman.xmission.com> Subject: M_Boats: MSOG Photo Site Hi All, 18 individuals have recently been given access to the MSOG Photo Site! Several new images have been posted by these individuals. I would love to see more Montgomery owners post current pictures and locations of their boats in the coming months! With enough participation, the site could become a directory of sorts. I would love to see some pictures from the Wrinkle Boat Ran-Tan posted after the event. I hope you all have fun! I was able to attend in 2015, but life prevents me from making it this year. Send an email to webmaster(a)msogphotosite.com and I will set you up with access! Thanks! Gerry Wyatt

1 0

Re: M_Boats: MSOG Photo Site
by GILASAILR＠aol.com 13 Feb '17

13 Feb '17

Gerry, I will see if I can get some photos - usually busy as the _ _ _ _ _ sailing but will work on it - Anyone in the Phoenix area - I am in need of crew for Saturday racing on Sage 17 - (last 'minute' work requirement for scheduled crew) contact me at the email address or 602 703-SAIL 7245 Thanks, GO In a message dated 2/13/2017 10:06:09 P.M. US Mountain Standard Time, wyattgs(a)gmail.com writes: Hi All, 18 individuals have recently been given access to the MSOG Photo Site! Several new images have been posted by these individuals. I would love to see more Montgomery owners post current pictures and locations of their boats in the coming months! With enough participation, the site could become a directory of sorts. I would love to see some pictures from the Wrinkle Boat Ran-Tan posted after the event. I hope you all have fun! I was able to attend in 2015, but life prevents me from making it this year. Send an email to webmaster(a)msogphotosite.com and I will set you up with access! Thanks! Gerry Wyatt

1 0

MSOG Photo Site
by Gerald Wyatt 13 Feb '17

13 Feb '17

Hi All, 18 individuals have recently been given access to the MSOG Photo Site! Several new images have been posted by these individuals. I would love to see more Montgomery owners post current pictures and locations of their boats in the coming months! With enough participation, the site could become a directory of sorts. I would love to see some pictures from the Wrinkle Boat Ran-Tan posted after the event. I hope you all have fun! I was able to attend in 2015, but life prevents me from making it this year. Send an email to webmaster(a)msogphotosite.com and I will set you up with access! Thanks! Gerry Wyatt

1 0

Sage 15
by George Iemmolo 13 Feb '17

13 Feb '17

There was a nice article in the latest SAIL magazine showing the Cat rig. Do not know if this is the boat Jerry was talking about in his SAC "Small Talk" column. Would love to sail one with a Flat Head. One can only wish at that price. I did not notice any spec for the draft in the article. Jerry I was wondering if any thought had been given to having a bulb on the end of the center board for additional righting moment. "We Can Not C ontrol the Wind But We Can Adjust Our Sails"

1 0

2017 WICR Windfinder forecast for Lake Pleasant (remember the key - 'forecast')
by GILASAILR＠aol.com 13 Feb '17

13 Feb '17

To the entrants at this years WICR: Please check out these and any of your favorite forecasts. https://www.windfinder.com/forecast/lake_pleasant_north check Lake Pleasant South too. http://www.sailflow.com/map#33.889,-112.28,10,1 Bear in mind conditions may rapidly change and this forecast is for six days from now. Bring something to keep yourself and crew dry and small headsails if you got 'em! - We have all seen these forecasts fizzle out so - ...could end up 12-15 and perfect! The YC RC will not start (probably postpone) the races until they are comfortable in their ability to run a "safe" race. Hey - this is what sailing is all about anyway right? If you are uncomfortable with the conditions - please do what you feel is right for your crew,boat and your self. The forecast front will probably blow through town on the prior evening and provide us with a clear beautiful day for sailing on Saturday!! That's my forecast and I'm sticking to it! (I will have a smock to keep the moisture off my shoulders) Please contact me if you have any questions (Dave S. is on the road) Gary O. _gilasailr(a)aol.com_ (mailto:gilasailr@aol.com)

1 0