Make sure you: DISABLE IP SOURCE_ADDRESS_FILTER if you want the routing to actually **work** as opposed to just **showing up** in the routing table correctly. -Jim

Robb Bryn wrote:

I'm configuring my first routed subnet on the TCHub and can't quite figure out what I'm doing wrong.

I have a Ascend P50 dialing in via ISDN with radius attributes of: Framed-Address = 208.150.95.241 Framed-Route = 208.150.95.240/29 208.150.95.241 1

After connecting, I can ping the ether address of the TCHub (208.133.28.51) from any of the subnet hosts can't ping anything past it. I can't ping any host on the subnet from the TCHub. Below is the output from the show ip network command.

HiPer>> show ip network test-ip-I4586

SHOW IP NETWORK test-ip-I4586 SETTINGS: Interface: slot:14/mod:2 Network Address: 208.150.95.241/H Frame Type: PPP Status: ENABLED Reconfigure Needed: FALSE Mask: 255.255.255.255 Station: 0.0.0.0 Broadcast Algorithm: IETF Max Reassembly Size: 3464 IP Routing Protocol: NONE IP Routing Metric: 1 RIP Interface Export Metric: 0 IP RIP Routing Policies: IP RIP Authentication Key: HiPer>>

I'm pulling my hair out trying to figure out what I've done wrong. A kick in the right direction would be greatly appreciated.

Thanks,

Robb Bryn

- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.