Well, you're almost there. Don't apply the outgoing filter. Alternatively write an different outgoing filter that allows everything. (Just restrict the packets that you're dialin user sends :-) -- Vance McIndoe InterConnect Ltd Phone: +64-4-494-1144 Fax: +64-4-494-1140 Mobile: +64-27-2477-608 Street: Level 2, Exchange Place, 5-7 Willeston Street, Wellington, New Zealand. Postal: PO Box 5527, Lambton Quay, Wellington, NZ. <mailto:vancem@interconnect.co.nz> <http://www.interconnect.co.nz> -----Original Message----- From: Kancha . [mailto:kancha2np@yahoo.com] Sent: Tuesday, 30 July 2002 11:25 PM To: usr-tc@mailman.xmission.com Subject: RE: [USR-TC] TC filter Hello: After executing the following commands i could not browse or do anything. Couldnot even ping. Prior to executing these commands though the filters were applied i was able to do anything. set interFACE slot:1/mod:[1-23] filter_accESS on set interFACE slot:2/mod:[1-23] filter_ACCESS on enable ip address_pool_filtering save all reboot i'm running 5.1 of hyperArc __________________________________________________ Do You Yahoo!? Yahoo! Health - Feel better, live better http://health.yahoo.com _______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc ###################################################################### Attention: This e-mail message is privileged and confidential. If you are not the intended recipient please delete the message and notify the sender. Any views or opinions presented are solely those of the author. ######################################################################