If you use a small one and slowly lift each end in a teter-totter fashion, you can pull them out without a lot of bending. I find I have better luck with a screwdriver than a "chip puller". The chip puller slips and is more prone to yank one side out quickly. On Thu, Aug 26, 2004 at 11:24:34PM -0600, Chris Hardy wrote:
Flat? And it doesn't bend the legs?
On Thu, 26 Aug 2004, Pete Ashdown wrote:
On Thu, Aug 26, 2004 at 12:24:22AM -0600, Chris Hardy wrote:
Ok. So my BZ is on the fritz, and being a pinmonkey for the most part, I am not that familiar with these boards. I do know that the in test mode the BZ is showing a T, which corresponds with "Time out". Should I just start swapping out the ram on the board? (I got some from Mike's Arcade).
Anyone know of a good PROM/RAM chip remover?
I like a jewelers screwdriver.