2.0.51 fixed that for us. It was quite a relief blake

-----Original Message----- From: Jim Baxter [SMTP:jim@atconnex.net] Sent: Thursday, August 31, 2000 8:25 AM To: usr-tc@lists.xmission.com Subject: Re: (usr-tc) bad modems in hiper dsp

Mike.,

Thanks for the info. I am running DSP code 2.0.81 and yes, the modems fail in pairs, mod:1 and mod:2 do not accept calls properly on one of my DSPs, and mod:13 and mod:14 do not work on another.

Jim Baxter Systems Administration AtConnex Networks jim@atconnex.net

----- Original Message ----- From: <mike@otherland.dyndns.org> To: <usr-tc@lists.xmission.com> Sent: Wednesday, August 30, 2000 11:00 PM Subject: Re: (usr-tc) bad modems in hiper dsp

...

On Wed, 30 Aug 2000, Jim Baxter wrote:

...

I have come accross several bad modems on my hiper dsps. I logged into the CLI on the hiper arc, and disabled them using

HiPer>> disable interface slot:xx/mod:xx

I would assume this would work fine, however now when all the other modems on the card fill up, my customers receive fast busy signals. This should not be the case as our phone lines are configured such that all calls should roll over onto the second PRI once the first one is full. Has anyone experienced this before? Is there a way that I can busy out a modem on a DSP so that the incoming calls will still roll onto the next pri?

You have assumed wrong.. This stops the HARC from using the interface but not the DSP from accepting a call on them. You should try setting the DS0s Local Out Of Service (L00S). Then you should get the desired effect if your spans are provisioned correctly.

I have never seen bad "modems" on a hiper DSP card. There are only 12 DSPs each with 2 virtual modems. Do you see failed modems in pairs, if not then its not a hardware problem. What code are you running?

- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.

- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.

- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.