Close, I think you've got the wrong SDL file version though- Try this: pcsdl -p1 -r9600 -vsd3.2.0 -vna5.2.2 -nsdnm -nnanm I recommend you bump the speed up to 57600 instead of 9600 though (flip dipswitches 1&2 up on the card & use -r57600). You're trying to flash it with the 5.2.2 code, right? Sometimes it helps if you reseat the NMC after starting the PCSDL if it doesn't take off right away. STeve das <das@gol.com> on 12/21/99 09:35:36 AM Please respond to usr-tc@lists.xmission.com Sent by: das <das@gol.com> To: usr-tc@lists.xmission.com cc: (Steve Valiunas/MW/US/3Com) Subject: (usr-tc) PCSDL, is there some sort of trick to this? I've read all of the documentation. I've now got some remote NMCs that have become unreachable via TCM. I figure that I need to go there and reflash them via PCSDL. I've never had to do this before, so I did my homework. This is what I'm typing: pcsdl -p1 -r9600 -vsd5.4.1 -vna5.2.2 -nsdnm -nnanm This should be all you need correct? It keeps giving me the following error message: Error: No such file or directory. So, I tried using the -d flag to specify C:\usr_sdl . But, that didn't seem to have any affect. Any ideas? I don't want to have to go all the way out there tomorrow without any way to bring these cards up. TIA, das -- ____________________________________________ Alex Substanley Global OnLine Japan Engineering Department Das Man TEL: 81-3-5334-1700 Systems Engineer FAX: 81-3-5334-1711 The Highest Quality Service, Bar None ____________________________________________ - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message. - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.