Kirti S. Bajwa wrote:

Hello List:

On out 3COM, I have setup ,Inactivity Time [min][S19]' settings to '12' minutes (Under TCM > HiPer DSP Cards > Configure > Call Control Options). However, when I test this feature by dialing-in from my PC into 3COM, the connection remains open for an extended number of minutes. I do not know what the maximum time it remains open but as of this post the connection is up for 40+ minutes with no activity from my PC.

Is ther anything wrong I am doing? How can I setup so the users disconnect when they reach the 'Inactivity Time"? First I must preface this with the fact that I use Radius to assign my idle-timeout. Next, make sure you understand that to the TC, idle means 0 octets in both directions. Make sure you monitor the session to check for traffic before you become sure it isn't doing what it is supposed to do.

-- Lewis Bergman Texas Communications 4309 Maple St. Abilene, TX 79602-8044 325-691-3301 800-299-6962