I'm taking a wild guess here, but your card may be bad. Normally, no matter what is set up on the card, I think it should get farther than that. It should display the boot-up menu at the console which gives you an option to erase the configuration, which basically clears everything out to default and gives you the chance to reconfigure the card. Like I said, just a guess, but if mine did that, I'd be swapping in a different ARC. - Joel -----Original Message----- From: Ahamed Bauani [mailto:bauani@yahoo.com] Sent: Friday, August 08, 2003 9:43 AM To: usr-tc@mailman.xmission.com Subject: [USR-TC] Factory Default of Hiper ARC Hello All I have a grate problem. Just few days ago our USR-TC is working find. But when we were going to change some configuration like IP address,IP Pool etc it start problem. My current problem is I cann't access to Hiper ARC by consol or from network (Telnet). When we reboot the TC with consol connected it's only showing : Booting*...* Loading Kernel....OK Then no other messages on consol. I tryied to telnet it over network but it didn't respond, ping it, result same. I am sure that this Hiper ARC card is OK, but some how I removed the IP of this and disable administration via consol. My current position is " I HAVE NO ACCESS TO THIS CARD!!" Think only it's be possible if somehow I can get it back to factory default. Do you have any idea how to set it factory default? Or any other suggation... really in a bad position. please help. Thanks in advance; Ahamed Bauani. __________________________________ Do you Yahoo!? Yahoo! SiteBuilder - Free, easy-to-use web site design software http://sitebuilder.yahoo.com _______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc