On a side note for those people frustrated by dead dsp's and console error messages: If you have a different NIC to try with the NAC give it a whirl. I've found cards will sometimes come back to life with the right nic/nac combo. Also...if you've ever had the Hiper Arc begin rebooting unexplainably and have started swapping out cards and even chassis....consider that maybe the problem is a particular DSP in the chassis. I have seen this problem several times when going through "questionable" cards. The Arc will only begin rebooting after the problem DSP is polled by TCM after it's bootup sequence. Todd -----Original Message----- From: usr-tc-admin@mailman.xmission.com [mailto:usr-tc-admin@mailman.xmission.com]On Behalf Of Gen Camiling Sent: Thursday, September 12, 2002 8:33 PM To: usr-tc@mailman.xmission.com Subject: [USR-TC] HiperDSP trace debug facility list Can anyone on this list provide me a link to any documentation or explanation regarding the trace debug facility list of the HiPerDSP? Been looking it up to all Commworks site and even on the Knowledgbase to no luck. All im wanting is the meaning of each facility. I usually use facility level 30 for tracing. -- Best regards, Gen ================================== Gen Camiling Chief Technical Officer International Micro Village, Inc. PHILIPPINES (63)(2) 7512130 http://www.imvi.com.ph mailto:gcamiling@imvi.com.ph ================================== _______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc