I've been trying to add a callback user with a static IP address to one of my hiperarcs, but have been having a couple of problems. I have a radius server as well, and I think it's skipping looking locally at all for the user. I get a basic authentication error when I try to dial-up (or telnet). Here is the basic config for the user I've got so far: INFORMATION FOR USER: callbacktest Status: INACTIVE Type: LOGIN NETWORK CALLBACK Expiration: NONE Message: this is a test DNIS Re Authentication: NO_REAUTH Special Xon Xoff Flow Control DISABLED Telnet Options: INVALID (D) Callback Type: STATIC Phone Number: "xxx-xxxx" Alternate Phone Number: (D) Input Filter: (D) Output Filter: (D) Modem Group: all (D) Session Timeout in seconds: 86400 Idle Timeout in seconds: 86400 Tap Status: DISABLED Tap Format: ASCII Tap Output: SYSLOG Tap Facility: LOG_AUTH Tap Loglevel: VERBOSE Port Limit: 2 Tap Address: 0.0.0.0 (D) Chat Script Name: PARAMETERS FOR LOGIN USERS: Login Service: TELNET TCP Port: 23 (D) Terminal: vt100 (D) Login Host Name: Login Host: 0.0.0.0 (D) Host Type: SELECT (D) PARAMETERS FOR NETWORK USERS: Network Service PPP Header Compression: TCPIP (D) Spoofing: DISABLED (D) MTU: 1514 (D) IP Usage: ENABLED (D) Address Selection: SPECIFIED Remote IP Address: 216.69.xxx.xx/H Next Hop Gateway IP Address: 0.0.0.0 (D) IP Routing: NONE (D) IP Routing Protocols: RIPV1 (D) IP RIP Routing Policies: IP RIP Authentication Key: Default Route Option: DISABLED (D) IGMP Query Interval: 125 seconds IGMP Max Response: 10 seconds IGMP Version: 2 IGMP Robustness: 2 IGMP Routing: DISABLED (D) Multicast Forwarding: DISABLED (D) Multicast Proxy: DISABLED (D) IPX Usage: ENABLED (D) IPX Address: 00000000 (D) IPX Routing: RESPOND (D) IPX WAN Usage: DISABLED (D) IPX RIP Update: 60 seconds IPX RIP Age Multiplier: 4 IPX SAP Update: 60 seconds IPX SAP Age Multiplier: 4 PARAMETERS FOR TUNNEL USERS: Tunnel Type: None (D) PARAMETERS for NETWORK PPP USERS Max Channels 2 (D) Channel Decrement Percent: 0 (D) Channel Expansion Percent: 0 (D) Expansion Algorithm: CONSTANT (D) Receive ACC Map: ffffffff (D) Transmit ACC Map: ffffffff (D) Compression Algorithm: AUTO (D) Compression Reset Mode: AUTO (D) Min Compression Size: 256 (D) Encryption Algorithm: NONE (D) Primary DNS Server: 216.69.xxx.xx Secondary DNS Server: 216.69.xxx.xx Periodic CHAP Timeout: 0 (D) Source Ip Address Filter: DISABLED (D) I'm mostly confused about the (D)'s everywhere, I haven't really dug very deep on my TCS boxes as far as adding extra users and such. Is there anything else I need to do on the user end, or on the hyperarc? I'm using version V4.2.32 of the firmware. Any help would be very appreciated. thanks! Erin Grooms System Administrator Erin Grooms System Administrator - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.