My primary radius was down and was switched over to secondary. I can't switch the active server back to the primary. Using code 5.0.80. I've seen this question addressed before using the set radius command, but neither fall through or round robin will switch it back. Any suggestions? My current setup looks like this: Local Authentication is: ENABLED Remote Authentication is: ENABLED Hint Assigned is: DISABLED Primary Server is: 000.000.000.150 Primary Destination Port is: 1812 Secondary Server is: 000.000.000.10 Secondary Destination Port is: 1812 Tertiary Server is: 0.0.0.0 Tertiary Destination Port is: 1645 Source Port is: 1645 Retransmission Timeout: 3 seconds Max Retransmissions: 10 Per Server Retry Count 3 Vendor Specific Attribute: ENABLED Prioritize Auth Server: DISABLED Active Authentication Server: 000.000.000.10 Send service type indication: ENABLED Authentication Counters Syslogs: DISABLED Authentication Counters Syslog Frequency: TWELVE HOURS Authentication Counters Syslog Reset: DISABLED Primary Auth Server Preference: 1 Secondary Auth Server Preference: 2 Tertiary Auth Server Preference: 3 RADIUS SETTINGS Fill Null Attributes: DISABLED Attribute Style: STANDARD NAS Port Style : STANDARD Authentication Algorithm: ROUND_ROBIN Interim Accounting Interval Status: DISABLED Interim Accounting Interval: 240 seconds IEA Radius Source Port Authentication ENABLED IEA User Radius supplied username DISABLED Send Unauthenticated STOP record ENABLED Report Acct IP Addr only for Primary Link: DISABLED Send only STOP Acct for failed services: DISABLED DNIS Authentication Service Type: 10 Radius NAS-PORT id style: DENSITY BASED Radius Resource Reclaim style: DRAFT Radius Reboot Indication style: FALL-THROUGH Authentication Failure Trap State : ENABLED John Mies - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.