I'm having an odd problem where a DSP card is dropping connections directly after the negotiation process finishes, but only on modems 1-12. Modems 13-23 work fine. When I enable modems 1-12, they always drop connections immediately after modem negotiation completes. I get this syslog message: ============ A call, call id = 720898, has arrived on interface slot:1/mod:12 A call is established, call id 720898, on interface slot:1/mod:12 The connection for call id 720898, on if slot:1/mod:12 was dropped for user UNKNOWN ============ The DSP card is a replacement from 3Com for a card that failed. The first replacement they sent did not work at all. I think this may also be a bad card, but am looking for tips on things to try. I have already restored all setting from default, saved it to NVRAM and rebooted the card many times. The fact that it does correctly answer calls on modems 13-23 makes me think its defective. I went into the DSP card console and ran chdev tslot X cmd tooserv soft where X is 1-12. Once that was done, all is fine (expect the card only has 11 active modems). I also notice that I am getting these syslog messages over and over. GWCMDM_AL, slot:1/mod:24 TAPI OPEN failed GWCMDM_AL, slot:1/mod:24 TAPI_OPEN failed, retrying Thanks for any tips, Dan - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.