Hi, i had recently bought the E1/Pri line from telecom, but after its hooked up to the total control ras Hiperdsp modem i get Carrier as green but Alarm is still glowing red. can someone help me what this indication mean and any configuration changes are needed in the ras box. Regards Anil
I believe that's indicating your D channel on your PRI is down. Check to make sure you're setup for PRI (message oriented) and that you have the correct switch type configured (whatever switch type the telco is using). Todd ----- Original Message ----- From: "Anil" <anilds@vasnet.co.in> To: <USR-TC@mailman.xmission.com> Sent: Saturday, August 02, 2003 3:16 PM Subject: [USR-TC] Pri Line
Hi,
i had recently bought the E1/Pri line from telecom, but after its hooked up to the total control ras Hiperdsp modem i get Carrier as green but Alarm is still glowing red.
can someone help me what this indication mean and any configuration changes are needed in the ras box.
Regards Anil
_______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc
Was your PRI ordered with a "D" channel. Is it just one PRI or more. If more, do you have NFAS turned on and the NFAD id set properly for each card? DSP Anil wrote:
Hi,
i had recently bought the E1/Pri line from telecom, but after its hooked up to the total control ras Hiperdsp modem i get Carrier as green but Alarm is still glowing red.
can someone help me what this indication mean and any configuration changes are needed in the ras box.
Regards Anil
_______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc
-- Douglas Phillipson Internet Consultant 702-295-8872 dougp@intermind.net Stop worrying about Microsoft peeking into your computer's data. Install GNU/Linux for a secure, highly stable Operating System.
participants (3)
-
Anil -
Douglas Phillipson -
Todd Bertolozzi