Kevin, we do this by turning on the logging on the NMC (using TCM) and sending the accounting info to our radius server. Of course, the NMC will need to be entered in the Radius clients file. Using TCM on each DSP, you can redirect the DSP traps so that the NMC can send them out to the Radius. regards, Colin Wantling ---------- From: Kevin Godby[SMTP:kevin@pcsia.net] Reply To: usr-tc@lists.xmission.com Sent: Friday, September 15, 2000 6:32 AM To: usr-tc@lists.xmission.com Subject: (usr-tc) Logging modem disconnect reasons Hello. I was wondering if anyone out there that's using 3Com/USR Total Control boxes (with HiPerARCs) know of any utilities that could store the disconnect reasons that the HiPerDSP generates (the actual modem disconnect reasons, not the general disconnect reasons that the HiPerARC uses) along with the person's usename and the date/time. They are wonderful for troubleshooting because they are so specific, but it's time-consuming to watch someone's session until they happen to get disconnected. :-) If we could somehow get the Total Control to send these to Vircom's VPRRS, that would be excellent, but I'm not too picky. Thanks for any ideas! Kevin Godby <kevin@pcsia.net> Professional Computer Solutions, Inc. 434 W. Second St. Phone: (641) 682-4691 Ottumwa, Iowa 52501 Fax: (641) 682-0633 - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message. - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.