If I recall you can map the modems on the quads to the ds0's. Can't remember exactly how to do that off the top without looking at TCM. That might be your issue. You may also want to try and reset the problem cards back to factory settings or copy all the settings from a good card over to the problem cards. Todd ----- Original Message ----- From: "Sergey" <a_s_y@sama.ru> To: "Discussion relating to the 3Com/US Robotics Total Control modem systems." <usr-tc@mailman.xmission.com> Sent: Tuesday, December 07, 2004 6:25 AM Subject: Re: [USR-TC] Problem with old interfaces (Quad Digital V.34 Modem)
On Tuesday 07 December 2004 14:54, Sergey wrote:
Do they become enabled after issuing a "enable modem_group slot:x"
This command influences on Admin Status. Isn't it ? But "Admin Status" is Up:
slot:2/mod:1 Down Up slot:2/mod:2 Down Up slot:2/mod:3 Down Up slot:2/mod:4 Down Up slot:3/mod:1 Down Up slot:3/mod:2 Down Up slot:3/mod:3 Down Up
One more note. Calling from telco reach to modems: I can see it on Quad modems led.
-- Regards, Sergey
_______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc