Total Control NETServer - Basic Setup and Configuration Answer Basic Configuration Commands for the Total Control NETServer card. These commands can be issued via a telnet sesion or the direct serial console connection: IP CONFIGURATION set net0 address<IP address> The IP address of the NETServer set net0 netmask<netmask> The netmask of the network that the NETServer is on set gateway<IP address><metric> The IP address of the gateway NETServer will be using and metric set namesvc<DNS | NIS> enable DNS or NIS for name resolution set nameserver<IP address> IP address of the DNS server for the NETServer set domain<domain name> sets the domain name the NETServer is on set net0 routing<ripv2><broadcast | listen | on | off> turns routing on (broadcast and listen), off, or broadcast or listen save all IPX CONFIGURATION set net0 ipx up Enable IPX protocol set net0 ipxframe<frame type> Frame type can be:Ethernet_802.2 Ethernet_802.2_II Ethernet_802.3 Ethernet_II Token-Ring Token-Ring_II Token-Ring_Snap set net0 ipxnet<network address> The network address taken from the Novell server. set ipxgateway<IPX network address><metric> The IPX address of the Novell gateway the NETServer will be using and metric set sysname<name> The name of the NETServer on the network save all RADIUS security and accounting set authentic<IP address of RADIUS server/UDP port><secret><V1 | V2> IP address of RADIUS server, default UDP port is 1645 set alternate<IP address of alternate RADIUS server/UDP port><secret><V1 | V2> IP address of alternate (backup) RADIUS server, default UDP port is 1645 set accounting<IP address of accounting server/UDP port><secret><V1 | V2> IP address of accounting server, default UDP port is 1646 set accounting 2<IP address of accouting server/UDP port><secret><V1 | V2> IP address of accouting server, default UDP port is 1646 Modem/S-Port Assignment set modem density<all | slot#><4 | 24 | 30> set the number of modems per slot (i.e. 24 for HiperDSP, 4 for Quad modems) set modem startslot<slot#> set the slot that the modems start in (i.e. first modem card in slot 3) set modem s<port# or port# range><active | inactive> enable or disable the modems show modem list the modems save all