Thank you Alex! So the IP's of the ARC, NMC and RADIUS server don't have to be able to talk to the gateway/router? They can be in Internet numbers with the pool and gateway in intranet IP's? Ray ----- Original Message ----- From: alex To: Ray Bagby ; Discussion relating to the3Com/US Robotics Total Control modem systems. Sent: Wednesday, September 17, 2003 1:57 PM Subject: Re: [USR-TC] changing IPs Telnet to arc and write: add ip defaultroute gateway <ip-address-of-gw-router> metric <metric> Also your gateway router has to know about IP pool (this pool have to be routed to arc). ----- Original Message ----- From: Ray Bagby To: usr-tc@mailman.xmission.com Sent: Wednesday, September 17, 2003 11:45 PM Subject: [USR-TC] changing IPs Greetings, I have a Total Control Chassis with 2DSPs and HiPer Arc and NMC. I've just found out I need to change the IP pool for the dial-in's. After I go to the HARM and change the pool it assigns the correct ip number to the caller but they are not able to access any resources. I know I'm missing something, but I'm not sure what it is. I read on an earlier post about the gateway. Where is that setting located? Is it something that can be accessed by HARM or should I use the TCM? Also, as long as the ARC, NMC and radius server can talk to each other is there any reason to change thier IP's? Thank you very much! Ray ---------------------------------------------------------------------------- _______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc