Also sprach Mike Moore
I have a Total Control chassis with two HiPerDSP cards in it. I monitor "Reason for Call Termination" with Total Control Manager. I am seeing a lot of "v42DisconnectCmd(26)" and "rcvdGatewayDiscCmd(62)". Any ideas as to what these mean? I am getting complaints from customers about disconnects as well. Thanks for your help!
Those are both normal "healthy" disconnect reasons. the v42DisconnectCmd means that the other modem on the line sent the v42 modulation code that informs the other end that it wants to end the call. The rcvdGatewayDiscCmd means that the Arc (or other gateway type of card, NETServer, wireless gateway card, etc.) sent the signal over the "dte" connection telling the DSP that it wanted to end the call. The DSP would then send the v42 code to disconnect to the other end. Essentially, its a race to see which of these is going to occur first in a normal call disconnect. Did PPP shut down first on our side so the gateway card gets the signal to the dsp first, or did PPP shut down first on the other side so that it gets signaled to the other side's modem and through the modem connection to our side? Both are normal and healthy...you need to be checking into the Call Termination reasons other than these. -- Jeff McAdams Email: jeffm@iglou.com Head Network Administrator Voice: (502) 966-3848 IgLou Internet Services (800) 436-4456 - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.