Your welcome...I enjoy helping when I can :-) Side note....once in a while you might have problems getting things going while using such a high baud rate. If that's the case....try it at 9600. Todd ----- Original Message ----- From: "Cindy Smith" <cindyo@ktc.com> To: "Discussion relating to the 3Com/US Robotics Total Control modem systems." <usr-tc@mailman.xmission.com> Sent: Thursday, October 16, 2003 5:05 PM Subject: Re: [USR-TC] HiPer Access Board requires software download
Thank you a bunch. I actually took a chance and used it before I read this. I figured what I have a got to loose.
It worked! I wonder whay TCM would not just do that?
Once again, Thanks!
--Cindy
On Thu, 2003-10-16 at 15:55, Todd Bertolozzi wrote:
use the .dmf file
Todd ----- Original Message ----- From: "Cindy Smith" <cindyo@ktc.com> To: <USR-TC@mailman.xmission.com> Sent: Thursday, October 16, 2003 4:32 PM Subject: [USR-TC] HiPer Access Board requires software download
Todd,
Thanks -- The other problem I have. All I have for this card is the dmf file Where do I get the .sdl file?
I can't find one anywhere.
thanks again
--cindy -- ----------------------------- Cindy Smith KTC iNet 830-896-1111 SysAdmin www.ktc.net -----------------------------
_______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc
_______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc --
Cindy Smith KTC iNet 830-896-1111 SysAdmin www.ktc.net -----------------------------
_______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc