You should be able to busy out channels just like you did before with a CT1. CT1s also support ANI if configured that way from the telco. The only functionality I figure you will lose is the ability to take incoming 64k clear channel ISDN calls on your Total Control chassis. Mike McHenry Systems Administrator MinnNet Communications, Inc. -----Original Message----- From: owner-usr-tc@lists.xmission.com [mailto:owner-usr-tc@lists.xmission.com]On Behalf Of Stainforth, Matthew Sent: Wednesday, September 22, 1999 1:49 PM To: 'usr-tc@lists.xmission.com' Subject: RE: (usr-tc) Channelized T1 vs PRI Part of the reason we're doing this is because CT1 is cheaper but I've never used CT1 before and I'm wondering what other functionality we're going to lose. I gather it will no longer be possible to do busy out the channels from this end and we'll also probably lose ANI too. Are there any other drawbacks that I might be overlooking? On Wednesday, September 22, 1999 3:46 PM, Mike McHenry [SMTP:mmchen@minn.net] wrote:
You should be able to use the same code for either a PRI or a channelized T1 on the DSP, just go into the TCM, select the T1 portion of the DSP (top LED below the power LED), click Configure-->Programmed Settings-->Trunk Settings
You will see a setting called signal mode, it should be set to robbed bit for a channelized T1 and message oriented for a PRI. Unless the telco is changing other things (ie switch type, etc) that should be the only setting you need to change when the telco changes your PRI to a channelized T1.
Mike McHenry Systems Administrator MinnNet Communications, Inc.
-----Original Message----- From: owner-usr-tc@lists.xmission.com [mailto:owner-usr-tc@lists.xmission.com]On Behalf Of Stainforth, Matthew Sent: Wednesday, September 22, 1999 1:29 PM To: 'usr-tc@lists.xmission.com' Subject: (usr-tc) Channelized T1 vs PRI
Overnight tonight the telco is changing one of our T1s to channelized T1 from PRI service for testing. I seem to remember that there is different code for the dual T1/PRI cards depending on which service you have but I'm using all DSPs now and I can't seem to have any CT1 specific code for these cards on TotalService. Does the one code base now support both CT1 and PRI or am I missing something?
Thanks...
Matthew
- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.
- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.
- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message. - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.