Yes that looked like it might be the problem. THe HiperArc slot hasn't changed, but the host computers version of HiperArc Manager was older, I upgraded to the same version, and now I can save /restore , as long as the Hiperarc is launched from the TCM but not if I launch it standalone.

Thanks,

Rod

----- Original Message -----

From: Todd Bertolozzi

To: Discussion relating to the 3Com/US Robotics Total Control modemsystems.

Sent: Thursday, December 30, 2004 6:12 AM

Subject: Re: [USR-TC] HiperArc Wont Accept Settings

Did the software version change from the old to the new card? Is there a DSP or some other card that is new or in a new slot?

Todd

----- Original Message -----

From: Rodney Rindels

To: usr-tc@mailman.xmission.com

Sent: Wednesday, December 29, 2004 4:59 PM

Subject: [USR-TC] HiperArc Wont Accept Settings

I get a

" No Data Available "

@1.3.6.1.4.1.429.4.10.4.0

message when trying to restore my hyperarc config from backup.

Is there some trick to this i'm missing?

Or could it be the Hiper Acess Router Mangager version I'm using? and if so? Where do I get another copy of it?

Thanks in advance ,

Rod

_______________________________________________
USR-TC mailing list
USR-TC@mailman.xmission.com
http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc

_______________________________________________
USR-TC mailing list
USR-TC@mailman.xmission.com
http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc