ok here is the situation... i have a chassis with 11 hiper dsp's active, dual hiper arc's and a hiper nmc and dual 130's i had 10 pri's running fine for the last two months. added the 11th pri yesterday. it seems to run fine for a few hours, fills up with callers etc. then it will get less "busy" than the rest of them, until it has nobody on it. when i check it all of the channels are remote out of service. if i do a hardware reset it goes back to normal for a few hours and then it does it all over again. i have checked all of a the settings and i can't figure out what is wrong. it seems to be identical to the other 10 pri's/hiper dsp's same version etc. can someone help me please? thanks matthew matthew de Jongh president the spa! internet voice (413) 539-9818 www.the-spa.com