Issue an In Service command to the PRIs. I've seen this before and that always fixes it. Jeff Binkley ASA Network Computing U>Hi All U>I need a little help here. I have a TC with a HIPER ARC, several U>HIPER DSP cards, some Quad Digital cards and a Dual PRI-Card NAC. I U>have been running for a long time with the HIPER DSP cards without U>problems. I now need to run the Quad cards and can not seem to get U>the Dual PRI card to work(it did work at one time). The PRI line is U>coming from a Lucent Definity 3G switch and works fine with the Hiper U>DSP cards. When I connect the PRI line to the Dual PRI card all I get U>is a busy signal, the link does show that it is up and there are no U>alarms.. U>The Dual PRI card has the following configuration U>Framing Mode ds1esf U>Line Coding b8zs U>Response to remote loopback ignore U>Auto Busy disabled U>Dial In Address No Address U>Dial-in/Dial-out Signal WINK U>ACK WINK Enabled U>Dial in Trunk type E&M TYPE II U>The settings above are set similarly on the Hiper DSP card. Any help U>would appreciated. U>Thanks in advance U>LOU U>- U> To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" U> with "unsubscribe usr-tc" in the body of the message. U> For information on digests or retrieving files and old messages send U> "help" to the same address. Do not use quotes in your message. U> CMPQwk 1.42 9999 - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.