Thus spake Scot bethke
Second Issue (and this is the big one) I have two PRI's, 23B+D, Bell atlantic says everything is fine with both of them. But they refuse to hunt from the first hyperDSP to the second. I plug in the first PRI into either DSP card and it takes calls and works like a charm till it gets to channel 23, where we get a fast busy from then on. Im hoping there is a special "Oh you havemore than one hyperDSP" button that I need to push. anyone know what might cause this?
Get Hell Atlantic back on the line and smack them upside the head with a clue by four. :) If the both cards are taking calls, then there's a problem with the hunting and that's all telco there. There is no way to configure your equipment to control the hunt group in any way. The originating side (the telco in this case) decides where to send the call, the receiving side has no say in the matter other than to possibly reject the call (resulting in either a fast busy/reorder tone type of response to the caller, or a user busy if its rejected with cause code 17). I suspect that they've set it up as two seperate trunk groups and not got the hunting between them configured correctly. -- Jeff McAdams Email: jeffm@iglou.com Head Network Administrator Voice: (502) 966-3848 IgLou Internet Services (800) 436-4456 - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.