Hello, I seem to have a problem adding a framed route to user on an ARC (not through RADIUS) Here's what I do: HiPer > add user test password xxxx network_service PPP type network enabled yes HiPer > set network user test ip remote_address 123.123.123.1/H HiPer > add framed_route user test ip_route 123.123.124.0/C gateway 123.123.123.1 metric 1 CLI - Network Name: °@ could not be resolved due to a problem interfacing with the NameServer. I have checked and cross-checked the syntax in the ARC and in the 4.1 documentation and it is correct. Now why the hell is a nameserver required to interact with a framed route ???? Is this a bug ?? (it did work on 4.0.29 though...) Is there another way to do it ? (except by doing it through radius....) Thanks for any replies... -- Robert von Bismarck Network Systems Engineer Petrel Communications SA / SPAN Tel : +41 22 304 47 47 Fax : +41 22 300 48 43 WWW : http://www.petrel.ch e-mail : rvb@petrel.ch - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.