You are correct and I had the same problem when I first ordered a used Total Control. The Total Control uses its only special cable <how nice>. You can find the Pin out information on CommWorks support site(www.commworks.com) if you wish to make your own cable or you could probably order one from WRCA.NET. Talk to Steve Riveria, he's great. Their number is 800-699-WRCA. Unfortunately, I have no experience with the EdgeServer card, but the system will operate without it as long as you add a NetServer Card or a HiperARC. Again, Steve could help you out their. Dan Houtz President / Sys Admin PennDigital Tech Inc. Ph: 814-272-5500 Fax: 814-272-5503 www.penndigital.net -----Original Message----- From: usr-tc-admin@mailman.xmission.com [mailto:usr-tc-admin@mailman.xmission.com] On Behalf Of Shawn Mitchell Sent: Friday, July 26, 2002 6:35 PM To: usr-tc@mailman.xmission.com Subject: [USR-TC] Questions.... I recently aquired a TC1000.... I know nothing about it... no manual's.. no software came with it... It has the following cards in it: HiPer DSP Card (two of them) Quad V.34 Modem Analog/Dig Modem EdgeServer Pro HiPer NMC PSU (two of them) Can anyone give me more info on any of these items? I've tried to get into them via the Console cable off the back of the unit, but I don't think it uses the same cable as the Cisco's do.... or someone reset the baud rate on the ports and it's not the default. The EdgeServer Pro currently runs NT 4.0... is this needed for correct operation of the unit? I've seen unit's like this w/o the EdgeServer in them, and they work just fine I am told. I'm wanting to replace NT with Linux or BSD on it for DNS Cache in the unit is why I ask. What are the HiPer DSP Cards capable of? I'm use to Cisco and Lucent (Ascend) equipment... first timer on a TC unit. Thanks for the info!! _______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc