Turn on dip switch 6, especially if you made your own serial cable... Mike Andrews (MA12) -=-=- VP & Sysadmin, Digital Crescent, Frankfort KY mandrews@dcr.net -=--=- mandrews@bit0.com -=--=- http://www.bit0.com "If you're not part of the solution.... you're part of the precipitate." On Mon, 16 Aug 1999, Scott Trautman wrote:
I just got 3 new HiperARC's. Yippee for me.
My means of configuring them is usually to put the console cable on and configure from there. And I've done several other ARC's this way.
This batch, however, I am getting as far as PROM vers 1.16 made June 16 1998..., Loading System .....OK and that's the last I see---
So I'm rather stuck. Per my NMC, it does load okay (all green), yet I can't get into it to set anything. Tried the usual disconnect, reconnect to the comm port, nope Tried the also usual Control-C,D,X,[,] for some kind of breakout
Nothing...nada....NMC says it's all good, but no more console output or input happening...
Any ideas? I'm hoping it's just as stupid a problem as I feel. Short work once I'm in....
SMT
Scott Trautman 608-240-4638,4637fax Global Dialog Internet www.gdinet.com 2810 Crossroads, STE LL2 Madison WI 53718
- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.
- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.