Do you have a Total Control chassis or a netserver 16 unit? Not clear from your post. Can you easily install cards in the front and back of the unit? Should you have the TC chassis, look at the type of quad modems you have. To enable v90, you must first enable x2 which is done in the NMC. At 08:48 PM 4/25/2001 -0300, you wrote:
Hii everionee.... sometime ago... i asked in this list about upgrade the totalcontrol v34 USR from v34 to v90.. Someguys say me that this is impossible ( because the Tcontrol is analog not digital ).., other send that i need buy anything .. etc etc. etc..) Well... sometime ago in 3com site had a upgrade ( beta firmware ) to v90. but i never see again ...
I need say that in this Tcontrol its impossible use upgrade card.. is all by firmware ( software ).. The modems are i think any version of the USR Courier modems ( because the firmware sofware from USR Modem Pool, the V34 Courrier standart modems begin with the same numer.. )..
Welll Pleaseee soemone know if possible i get this firmfware to upgrade my tcontrol?? pleasee?? ( try call the 3com support is lose my time)..
my apologise for my english.. thakss..
- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.
Thanks, Greg Coffey, Visionary Communications V 307-234-5443 x11 ===================================================================== 100 N. Center St. #100, Casper, WY 82601 WWW.VCN.COM - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.