This I can do a software reboot on the DSP cards and have no problems it when I try a software reboot on the hiper arc card that causes the problem -----Original Message----- From: usr-tc-admin@mailman.xmission.com [mailto:usr-tc-admin@mailman.xmission.com] On Behalf Of RickL@solunet.com Sent: Wednesday, December 04, 2002 11:46 AM To: usr-tc@mailman.xmission.com Subject: RE: [USR-TC] Hiper Arc Problems Please Help Travis, When you reboot an individual card, the system loads the configuration from the local flash on the card. By contrast, each card will pull their configuration for the flash on the NMC when the system is powered down and brought back up. All you should have to do is reboot the chassis, then save all of your modems to their local flash when they come back up. Then you can reboot individual cards or the whole chassis without killing a thing. (choose card, "Configure", "Action Commands", Choose software, the "Save both T1/E1 and modems TO NVRAM") Hope this helps.. Rick Team Solunet -----Original Message----- From: Travis M. Best [mailto:sysadmin@sunqwest.net] Sent: Tuesday, December 03, 2002 9:09 AM To: usr-tc@mailman.xmission.com Subject: [USR-TC] Hiper Arc Problems Please Help I have a problem where if I reboot the chassie from the telnet window of do a software reset on the hiper arc it busy out my modems with a fast busy but if I power down the unit and power it backup everything is ok. Has anyone seen this before??? Is this some setting I am missing some where? Please help Thanks, Travis Best Systems Administrator