Hello Brian, If it's a new DSP, perhaps you can check if it's the new DSP model. These new cards show up as rev 0.49.0, and are easily recognizable when you pull them out: Double Sided, 6 DSPs on one side, 6 DSPs on the back DIP switch for Console port speed (the previous model had no dip switch for port speed) 2 empty DSP sockets on each side (used for the E1 model) Lack of daughterboard (E1) connectors, and penny sized PPC chips (instead of the rather big PPC chip on the older rev) I've had some trouble flashing these cards with TCM, but once I flashed them to 2.0.51 through the AUX port, they were fine and I was able to re-flash them succesfully with TCM. Nick Brian wrote:
On Fri, 28 Jan 2000, Mike wrote:
I have a new DSP card that first of all wouldn't allow me to flash new code to it through TCM, it kept giving a "TFTP error: Access violation" error. So I hooked up to the console port and was able to upload the 2.0.51 code to it. After I reset the card it came up fine and reported the correct software version, but after a couple of hours TCM reports the card failed. I can do a hardware reset and it will be fine for a few more hours, but it will eventually report failed. What can I do to resolve this? Thanks.
Make sure your write community string is correct. It sounds like the issue you are having is more of an NMC issue than a DSP issue.
What NMC code? is it a HiperNMC? Is the NMC communities set right?
Brian
-- Mike Wilker Director of Network Operations Local Link, Inc.
- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.
-- Nicolas St-Pierre Systems Engineer Internet Access Solutions Ltd. Tel (905) 469-4953 Fax (905) 469-4954 - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.