Hello Alex & ??:
I have followed both of your advice, by
performing the following steps (O/S is Win NT 4.?):
·
Setup IP
address (63.113.255.9)
·
Setup
Netmask (255.255.255.0)
·
Setup
Gateway Address (63.113.255.1 => I assume this is the IP address of my CISCO
26?? Router)
·
Change
Community Settings (tibp for Public & tibr for Private)
·
Save in NVRAM
·
Reset Hiper
NMC
·
Open a
new chassis under name TIB-TC1
·
Target
Host 63.113.255.9
·
SMTP
Community Setting
a. Read Only: tibp
b. Read+Write: tibr
c. OK
I have done it half a dozen time and receive the same error message:
TIB-TC1
Device
not responding
Refer
to the troubleshooting section of the user guide
For your information, I can PING the NMC
& Gateway ( 63.113.255.9 & 63.113.255.1 )!!!
Do you think that Win NT 4.? May be the problem? HELP.. I am
going crazy!!
Kirt
-----Original Message-----
From: alex [mailto:alex@wanex.ge]
Sent:
To: kbajwa@tib.com
Subject: Re: [USR-TC] Total
Control manager
Set up NMC card: put IP address and
netmask, gateway address. Change commuity strings. Then connect NMC to LAN.
Run TCM. Open a new chassis (or
smth. like this), write NMCs IP address and read/write community strings.
Thats all.