-----Original Message-----
From: Joel - Fox Computers [mailto:jfox@foxcomputers.com]
Sent: Thursday, April 03, 2003 2:19 PM
To: Discussion relating to the 3Com/US Robotics Total Control modemsystems.
Subject: RE: [USR-TC] hd020019.dmf

yeah- that's what I was talking about...

-----Original Message-----
From: Adam Barnhill [mailto:adam@semo.net]
Sent: Thursday, April 03, 2003 1:12 PM
To: 'Discussion relating to the 3Com/US Robotics Total Controlmodemsystems.'
Subject: RE: [USR-TC] hd020019.dmf

Downgrading Code You may find it necessary to revert back to Total Control 1000 Release 4.3

code on either the DSP multispan card or the HiPer DSP card. Follow these

steps to revert back:

1 Flash to Total Control 1000 4.3 compatible code. (Previous versions are not

usable until the card successfully loads/boots 3.1.x code.)

2 Before you upload the code you must log into the console, or telnet, and enter

the following commands:

chdev mdm1

at-re1

3 After the prompt returns, initiate the code download as usual and reboot

when it is completed.

 

 

--
Adam Barnhill
Support Engineer, TotallyFabricated.com
Information Technology Engineer, Poplar Bluff Internet, Inc. / Semo.net
P.O. Box 190 | Poplar Bluff, MO 63902 | 573.686.9114, <http://www.semo.net/>
        Home of TotallyFabricated.com the creators of Total Scrutinizer

-----Original Message-----
From: usr-tc-bounces@mailman.xmission.com [mailto:usr-tc-bounces@mailman.xmission.com] On Behalf Of Joel - Fox Computers
Sent: Thursday, April 03, 2003 12:28 PM
To: Discussion relating to the 3Com/US Robotics Total Control modemsystems.
Subject: RE: [USR-TC] hd020019.dmf

Warning - I don't know what it is, but there are some specific config changes you have to make to a card to downgrade from 3.5.x.  I think someone said something about turning them into doorstops if you do this wrong.

 

I'd recommend re-uploading the 3.5.x first.

 

Also - 3.5.12 is the devil - you should go 3.5.105 or 3.5.109.

 

- Joel

 

-----Original Message-----
From: David Swearingin [mailto:david@carolnet.com]
Sent: Thursday, April 03, 2003 11:26 AM
To: usr-tc@mailman.xmission.com
Subject: [USR-TC] hd020019.dmf

I tried upgrading from hd020019.dmf on a HiPerDSP to hd030512.dmf.  Now the card doesn't work at all.  I want to revert back to the hd020019.dmf but I can't find my file.  Can someone email me this file?

Thanks.