Yes, It worked well
up to the end of the last week.
So, I have done
next:
I have checked chips on my NIC card and I have
found two diodes and one chip ds1488 which were broken.
This chain of the components work for sending
signal to the console port. It is not critical.
I ve repaired it. I cuted chip ds1488 and
changed diodes. I am not sure about other components. But it look good. I ve
tested current, voltage etc.
Yesterday I have tried to install it. On power on
Rn/Fl Led blinked red first 15 minutes than Rn/Fl was stable
green.
Eth port didnt react first 15 minutes but
after LAN Rx Led started to blink, i.e. reacted to LAN
packets.
Also Ethernet port Leds started to
flashing.
ARC was not pingable. Also I was unable to control
the ARC by TCM.
10x in
advance,
Murad
----- Original Message -----