I couldn't say what it means, but I had a card do the same thing to me. After about 5 more resets and a couple reseats it decided to die completely. Leaving it running in a chassis for 15min or so, would cause it to freak and reboot (usually unsuccessfully). Support people replaced the card. -- Adam -----Original Message----- From: usr-tc-bounces@mailman.xmission.com [mailto:usr-tc-bounces@mailman.xmission.com] On Behalf Of Cindy Smith Sent: Saturday, October 18, 2003 11:53 AM To: usr-tc@mailman.xmission.com Subject: [USR-TC] DSP Card Diagnpstoc Power-up Failure I get the following from the Console Prompt when rebooting a DSP card. (Note usually rebooting again will clear this) The card is not currently in use, so I am not sure what happens if the card is in service for a while.
!!----------> SDL2 for the PPC403 <------------!! __ Enter Download Trigger __ Flash Image Has Valid CRC, Loading Image.... Diagnostic Power-Up Failure Manufacturing Info -> 1AAA13M0 Mode/Env -> 1/0 Fault Code -> 0-219-224-1 Expected Data -> f005400c Received Data -> b005400c Text Message -> The ACP thinks it passed but the BM say it failed here, f ail num = ACP --------------------------------------------- Does anyone know if this fault code points to anything in particular. Thanks, --Cindy Smith _______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc