You're not advertising rip through your Ethernet interface which is identified by the following: Number RIP Interfaces: 0 If you name your network IP add the following command: set ip network ip routing_protocols ripv2 save all Todd -----Original Message----- From: usr-tc-bounces@mailman.xmission.com [mailto:usr-tc-bounces@mailman.xmission.com] On Behalf Of Andre Dalle Sent: Thursday, November 27, 2003 7:44 PM To: usr-tc@mailman.xmission.com Subject: [USR-TC] IP RIP/routing-advertisement I have my HiperARC cards working fine with static routes in our router, but I want to get dynamic routes working since we're spanning 2 subnets now. I've enabled RIP, but the HiperARC doesn't seem to be advertising any routes: hiper0-nic0>> show ip rip counters IP RIP COUNTERS Received RIP Packets: 0 Transmitted RIP Packets: 0 Received incorrect RIP Packets: 0 hiper0-nic0>> show ip routiNG IP ROUTER SETTINGS IP Router Administrative Status: ENABLED IP Static Remote Routes: ENABLED IP Router ID: 134.117.137.3 IP Autonomous System Number 1 IP Max Table Size: 11400 IP Max Metric Entries: 512 IP RIP ENABLED IP Number RIP Interfaces: 0 IP Number RIP Neighbors: 0 IP RIP Flags: METRICS SEND_REQUEST I can't find anything in the docs about setting up RIP interfaces or neighbours. What must I do to get this going? -- Andre Dalle [adalle@ncf.ca] Systems Administrator, National Capital Freenet [http://www.ncf.ca] _______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc