Sounds like you're using the read string instead of the write community string. Todd ----- Original Message ----- From: "Joel - Fox Computers" <jfox@foxcomputers.com> To: "Discussion relating to the 3Com/US Robotics Total Control modemsystems." <usr-tc@mailman.xmission.com> Sent: Sunday, August 15, 2004 11:39 PM Subject: [USR-TC] Problem Figuring out E1 DSP's
I got a chassis with 7 E1 DSP's in it, a Hiper ARC, and a Hiper NMC. At
first, TCM wouldn't even let me see settings on the DSP's. Someone here on the list suggested updating the code on the NMC. So I loaded 8.6.3 on it. Then I could see the trunk settings.
NOW... if I go to Configure->Actions/Commands, it won't let me run any
commands on the DSP's. I can't even force a hardware reset. After I try to execute any command, in the status area at the bottom of the window, it displays the Device(s), pauses for a few seconds, then just says "No Command" under the Command column and nothing happens.
Any suggestions?
Thanks,
Joel
-----Original Message----- From: David E. Smith [mailto:dave@mvn.net] Sent: Friday, August 06, 2004 11:50 AM To: Adam Barnhill Cc: usr-tc@mailman.xmission.com Subject: RE: [USR-TC] Help: Dropping packets for not-in-use IPs
On 6 Aug 2004 at 11:40, Adam Barnhill wrote:
HiPer>>enable ip send_host_unreach_for_pool
THIS is why I love mailing lists. Thanks!
(If the semo in semo.net is for Southeast Missouri, I owe you a beer next
time
I'm in Cape Girardeau.)
David Smith MVN.net
_______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc
_______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc