check the ds0 service states in tcm, or from the dsp command line: chdev span dis atstat brian On Thu, 27 Jan 2000, Scot Desort wrote:
OK. Duh on me.
Where can one tell if modems are soft-busied. That is what was wrong. I have since restored to service all of those channels. But before I figured it out, there didn't seem to be anywhere in TCM that told me the channels were busied out. Did I miss something???
----- Original Message ----- From: Brian <signal@shreve.net> To: usr list <usr-tc@lists.xmission.com> Sent: Thursday, January 27, 2000 9:55 AM Subject: Re: (usr-tc) Problem with new PRI
channel/slot mappings, check them.
ds0 service states, check those.
Go into session monitor, and look at ds0 statistics, it may also show something.
On Thu, 27 Jan 2000, Scot Desort wrote:
We added another PRI to our hunt group today. Telco says all trunks in
group
are set to UCD hunt method.
New PRI is only taking 1 call on channel 1. It has taken both analog and digital calls on that channel. I have checked the card in TCM and all channels are enabled. I have done a hardware reset on the card, with no effect. Have not had the opporunity to switch the PRI to see if the problem follows the card or the trunk.
Any ideas on what I might be missing?
-- Scot
- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.
----------------------------------------------------- Brian Feeny (BF304) signal@shreve.net 318-222-2638 x 109 http://www.shreve.net/~signal Network Administrator ShreveNet Inc. (ASN 11881)
- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.
- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.
----------------------------------------------------- Brian Feeny (BF304) signal@shreve.net 318-222-2638 x 109 http://www.shreve.net/~signal Network Administrator ShreveNet Inc. (ASN 11881) - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.