On the problem with the sportster - according to the doc that came with DSP 3.5.109, under Unresolved Issues, MR # 48092, "Dial in with Sportster V.92 with no compression drops", workaround = "Verify Data compression (&K) enabled on both ends" -----Original Message----- From: Walt Gnann [mailto:wgnann@islc.net] Sent: Monday, January 27, 2003 12:17 PM To: usr-tc@mailman.xmission.com Subject: [USR-TC] Problem with USR Sportster 56K and v.92 I recently upgraded our TC chassis to NMC 8.6.3, HARC 5.3.110, HDSPs 3.5.109. I enabled v.44 data compression and all the v.92 settings on the HDSPs. I had a few problems with folks staying connected while the v.92 PCM Upstream setting was enabled. Basically they would connect fine then get dropped after a few minutes with a failure to retrain error. So, I disabled PCM and everything seemed fine. Newest problem is with a Sportster 56K modem. It will start to handshake then a second or two into the handshake it will give a long, high pitched tone and fail to connect. If I disable the v.92 master setting on the HDSP it will connect just fine. Has anyone else encountered this? Any suggestions? Walt ----------------------------------------------- Walter N. Gnann ISLC, President wgnann@islc.net http://www.islc.net 843.770.1000 fax: 843.770.1002 ----------------------------------------------- _______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc