At 01:46 PM 9/22/99 -0500, you wrote:
You should be able to use the same code for either a PRI or a channelized T1 on the DSP, just go into the TCM, select the T1 portion of the DSP (top LED below the power LED), click Configure-->Programmed Settings-->Trunk Settings
You will see a setting called signal mode, it should be set to robbed bit for a channelized T1 and message oriented for a PRI. Unless the telco is changing other things (ie switch type, etc)
Switch type makes no difference on a CT1
that should be the only setting you need to change when the telco changes your PRI to a channelized T1.
You need to reboot the DSP card, and most likely the ARC card. In our experience, the ARC still shows it as a 23 channel circuit 'till you reboot, then it goes to 24.
Mike McHenry Systems Administrator MinnNet Communications, Inc.
-----Original Message----- From: owner-usr-tc@lists.xmission.com [mailto:owner-usr-tc@lists.xmission.com]On Behalf Of Stainforth, Matthew Sent: Wednesday, September 22, 1999 1:29 PM To: 'usr-tc@lists.xmission.com' Subject: (usr-tc) Channelized T1 vs PRI
Overnight tonight the telco is changing one of our T1s to channelized T1 from PRI service for testing. I seem to remember that there is different code for the dual T1/PRI cards depending on which service you have but I'm using all DSPs now and I can't seem to have any CT1 specific code for these cards on TotalService. Does the one code base now support both CT1 and PRI or am I missing something?
Thanks...
Matthew
- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.
- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.
--- Clayton Zekelman Managed Network Systems Inc. (MNSi) 875 Ouellette Avenue Windsor, Ontario N9A 4J6 tel. 519-985-8410 fax. 519-258-3009 - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.