You could try either of these commands;

enabLE modeM_GROUP ALL (or by specific interface)

enable interface slot:1/mod:[1-6]

Other than that I’ve seen old arc/nmc configs cause issues.  Try and make sure you’re starting off with a clean config on everything if you’re still pulling hair.

Todd

---

From: usr-tc-bounces+berto=core.com@mailman.xmission.com [mailto:usr-tc-bounces+berto=core.com@mailman.xmission.com] On Behalf Of Shahrooz Sharghi
Sent: Tuesday, May 31, 2005 8:32 AM
To: Discussion relating to the 3Com/US Robotics Total Control modemsystems.
Subject: [USR-TC] e1 interfaces are down

I have a TC1000 includes 1 130 Amp PS + 1 hiper NMC +  1 Hiper ARC + 1 E1 DSP (ISDN Code) configuration.

in the "List interface" command shows the channels are down:

Interface                        Oper    Admin
Name                             Status  Status

slot:1/mod:1                     Down     Up
slot:1/mod:2                     Down     Up
slot:1/mod:3                     Down     Up
slot:1/mod:4                     Down     Up
slot:1/mod:5                     Down     Up
slot:1/mod:6                     Down     Up

I tested that configuration (exact cards) on 3 different chassis with same result. The only Chassis it shows up up in list interface was one chassis (3com blue)

What do you think about my problem? how can I use those cards in other chassis?

Thanks a lot