|-----Original Message----- |From: owner-usr-tc@lists.xmission.com |[mailto:owner-usr-tc@lists.xmission.com]On Behalf Of Horace Demmink |Sent: Monday, October 04, 1999 11:45 AM |To: usr-tc@lists.xmission.com |Subject: (usr-tc) Dual channel ISDN problem. | | | |I have been trying to figure out a problem that one of my customers has |been having. They are dialing up with a 3COM NetBuilder to our TC |equipment. The first channel comes up fine, but the second one will not |come up. The NetBuilder attempts to bring it up, fails, and waits a few |seconds before trying again. ISDN is $.08 per call in this area so they |are racking up quite a bill. I have never seen this before with any other |customer, and as far as I know they are the only ones with a 3COM |NetBuilder, so I am assuming that it is a problem or misconfiguration with |their router. Is anyone else familiar with these things? Thanks very much |in advance for any help or advice anyone can offer. | |We are running: | |ARC 4.2.32-1 |DSP 2.0.81 | |Here is the relevant section of their radius entry: | |username Auth-Type = System | Service-Type = Framed, | Framed-IP-Address = xxx.xxx.xxx.xxx, | Framed-IP-Netmask = 255.255.255.255, | Framed-Protocol = PPP, | Framed-Route = "yyy.yyy.yyy.yyy/30 0.0.0.0 1", | Framed-Routing = None, | Framed-MTU = 1500, | Idle-Timeout = 0, | Port-Limit = 2, | Framed-Compression = Van-Jacobson-TCP-IP | | |And the following is about a minutes worth of a dump of a monitor ppp from |the arc: | |Decode tracing started, press ESCAPE to stop; press X for hex tracing. | |Incoming PPP Data on interface: slot:15/mod:20 | LCP ECHO_REQ 00 cc f7 cf d8 2e c8 68 Your PPP trace is of the channel that is already up and is of now use for debugging this problem. What needs to be seen is the LCP seesion through IPCP on the first channel and then the PPP trace of the second channel failing.. -M - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.