mmm3@cornell.edu wrote:
Hi,
I've used Cisco AS5300's and PM3's longer than I have been using Total Controls, but acquired some some months ago in a merger.
I need to let the telco know how line provisioning is handled on our end. In my Cisco's and PM3's, I can find info like:
switch type primary-5ess framing esf linecode b8zs, etc
but can't find corresponding info in the two Total Control boxes that I have.
How do I find that?
Lisa:
On the DSP card, click on the second LED down (this highlights all four carrier LEDs), go to "Configure-->Programmed Settings...-->Trunk Settings".
She's going to need Total Control Manager to do that. There are special cables you can use to console into each DSP card if you don't have TCM, or you can set the ARC to proxy telnet into the HiPer DSP cards and program them through the command line. Needless to say you'll need some documentation if you don't have TCM. -Ron