Hi guys... I have a NMC we purchased a long time ago that we need to put into service ASAP. We just discovered one of our NMCs was not X2 enabled, and this card is X2 enabled... but I don't have the SNMP write password. The firmware is 4.3.4, and on bootup at the RS232 console all I can get is "PASSWORD:"... if I use the 'public' read password, I can get in, but not change anything. I tried using pin 5 to boot to the default settings, but it still asks for a password! I am afraid to use the CMOS clear jumper, as I fear it will erase the feature enable status of the X2 enablement. Would this clear the X2 enable out? Thanx in advance. ----Steve Stephen Amadei Dandy.net CTO Atlantic City, NJ - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.