This is from an old list message.... perhaps it will help. make sure there are no conflicts between lan and wan and wan2. If wan2 address is 0.0.0.0, then put something in for it and a subnet mask to go with it. Randy McMillan PacInfo -----Original Message----- From: usr-tc-bounces+randy=pacinfo.com@mailman.xmission.com [mailto:usr-tc-bounces+randy=pacinfo.com@mailman.xmission.com] On Behalf Of Jason Keeling Sent: Monday, January 05, 2004 1:30 PM To: usr-tc@mailman.xmission.com Subject: [USR-TC] Problem with NMC card I have a new rack I am trying to get up and running, but when I try and set the LAN IP to the desired IP address and save the settings to NVRAM, I get the following error: Error: Networks should be on different Interface Subnets. I've looked around at the other settings (WAN etc.) and all of those are set to a different network address, so I'm not sure what the error involves. Thanks for the help in advance. -- Jason Keeling Texas Communications 1389 N. Harvey Mitchell Pkwy. Bryan, Tx. 77803 979-775-6239 --- [This E-mail was scanned for viruses by Declude Virus] _______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc