Just my 2 cents....you're better off no matter what gear you're learning how to use to learn the CLI even if it comes with a GUI. There's this nifty feature in the command line and most CLI's that all you have to do to access it is type ? Combined with that and the information provided online you should be able to figure out how to configure just about anything on the CLI. Also, the CLI will give you better debug/troubleshooting info. It will pay off later to learn how to use it today. Todd ----- Original Message ----- From: "Wayne Barber" <barberw@tidewater.net> To: "Discussion relating to the 3Com/US Robotics Total Control modem systems." <usr-tc@mailman.xmission.com> Sent: Thursday, March 18, 2004 10:05 AM Subject: Re: [USR-TC] Hiper Arc Code 5.3.3
Years ago, I took a class at US Robotics on configuring the TC1000. The instructor, who was a contractor, told us to never trust HARM. It didn't always do what it was supposed to do. He recommended using the CLI. AFAIK, HARM is no longer being supported or updated.
On 17 Mar 2004 at 20:09, Lewis Bergman wrote:
Kris McElroy said:
I have Hiper Arc Code 5.3.3 on a Hiper Arc. I am trying to access it
via
HARM 2.2.6 and it says "Your Router is running 5.3.3. HARM 5.2 works with ARC 5.2*
How Can I manage this Hiper Arc with HARM? I don't know if there is an update or not. The ARC is pretty easy to config with the CLI though. Sorry, but I haven't heard of any new releases but again, I have never even seen HARM. -- Lewis Bergman Texas Communications 4309 Maple ST. Abilene, TX 79602 325-695-6962 ext 115
_______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc
Wayne Barber Coastal Telco Services
_______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc