Hi Russel, Go to the command line of the DSP chdev Span
cmd rd (Default) cmd sv (Save) re (reset)
Reconfigure you line settings if needed Also if you are still having problems check different rate adaptation calls IE Sync PPP, v110, v120 and x75 if all are affected I would check the modem setting is set to at*v2=0 Auto detect ( Default) Another thing you could look at is mdm> at-af This will give you a failed reason mdm>at-ad This will give you a disconnection log. There lot of other possible areas to look at as in running a trace but start with the above. Ray W "Russ Miescke" <russm@powerweb.net> on 31/12/99 23:51:46 Please respond to usr-tc@lists.xmission.com Sent by: "Russ Miescke" <russm@powerweb.net> To: usr-tc@lists.xmission.com cc: (Ray Whelan/IE/3Com) Subject: (usr-tc) ISDN Calls on TC We are having a real problem getting ISDN calls to connect to our HyperDSP cards. The calls work fine on our old netserver TC units, but will connect and just hang, connect only one line or not connect at all on the new units. Any tricks to this? Russ Miescke Power Web Connect - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message. - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.