Kirti S. Bajwa said:
Hello List:
I am almost done except for that 3COM Chassis cannot hold the final settings. To explain further here is the step-by-step routine I am following:
----------
In TCM, [make all necessary changes to HiPer DSP, then:]
Configure->action/Commands Software-> Save Both T1/E1 and Modem to NVRAM > Execute Software-> Software Reset > Execute
[make all necessary changes to HiPer NMC, then:]
Software-> Save Chassis to NVRAM > Execute
At a console prompt type save all There is a file called config or some such on the hiperarc where all the configs are stored I believe. I really don't know about the gui stuff as I use it mainly for updating firmware. -- Lewis Bergman Texas Communications 4309 Maple ST. Abilene, TX 79602 325-695-6962 ext 115