Hi Dan, Check the configuration in case the Dual E1 cas is sending out AB bits set for 11 backward which blocks calls, also the Telco could be sending Blocking. Debug Ctrl D 1 Cas Monitor Trace this allows you to see AB bits changes ,Time Stamts channel call coming in on line, Its a good starting point. Or try 2 Cas monitor trace it monitor all channels be careful this can slow down the system. Try the first trace and make a test call. Regards Ray Whelan Dan Borlovan <danb@dnttm.ro> on 25/01/2000 15:02:24 Please respond to usr-tc@lists.xmission.com Sent by: Dan Borlovan <danb@dnttm.ro> To: usr-tc@lists.xmission.com cc: (Ray Whelan/IE/3Com) Subject: (usr-tc) Quad ana/dig modem not taking calls (another case of) Hello, I have a totalcontrol chassis with the following cards: - 1 dual e1/cas - 8 digital quad modems - 6 analog/digital quad modems - 1 hiper arc - 1 hiper nmc (p5nmc) All cards have at least tcs3.5 software Modem signal source is pritdm. The dual/e1 card recognizes the modem cards. I have 2 E1 (30 channels) active. The problem is that the ana/dig modems do not take calls. All modems (both dig and ana/dig) have the same configuration. What seems to happen: - a call arives; the dual/e1 tries to communicate with the modem (status is 'dialling-in'); after about 10s failes and the caller gets a busy signal from the telco. Meantime modem shows no reaction (doesn't go off-hook) What was tried: - software reset, hardware reset, chassis powerdown/powerup - reinserting modem cards - chaging modem cards - changing modem source from pritdm to nic, inserting an analog line and making a call works - so the modem and the harc are fine - swapping slot positions for dig and ana/dig modems - the dig modems take calls, the ana/dig don't The same configuration seems to work in other places using same hardware. If you have any suggestion, I'll be glad to try. If needed I can provide debug from the dual/e1 card (the ctrl/d menu), just tell me which debug options to enable. Thanks, Dan -- Dan Borlovan <danb@dnttm.ro> System Administrator, Network Operation Center Dynamic Network Technologies - Timisoara, Romania Telefon: +40-56-204967 FAX: +40-56-220201 - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message. - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.