If you are making span-level changes, make sure you "save T1/E1" on the HiperDSP, then from the NMC, "save chassis to NVRAM" to be safe. The last step is required if you have auto-config enabled on the NMC. Also, you should be using 6.2.17 NMC code (requires TCM 6.0 as well) with the 2.0 HiperDSPs. Note that there is a s/w reset and a h/w reset available on the HiperDSP through TCM. Depending on how you save and how autoConfig is set, each may give you different results. STeve "Sam Lowe" <slowe@universalcom.net> on 12/08/99 08:06:35 AM Please respond to usr-tc@lists.xmission.com Sent by: "Sam Lowe" <slowe@universalcom.net> To: usr-tc@lists.xmission.com cc: (Steve Valiunas/MW/US/3Com) Subject: (usr-tc) TCM 6.023 We seem to be having a problem saving settings on our HiPer DSP cards using TCM (we think). When we set the switch type and reset the card it would revert back to the default setting (5ESS). When the 3Com tech set it, it stayed? Also the cause codes, timeslot mapping and blocking, and timeslot service configurations are not taking. We set them, save the settings to NVRAM, and reset the card and all the settings revert, BUT, when we restore from nvram all the settings get the correct values? Any ideas would be appreciated. We are running 4.1.59 on the ARC and 2.0.81 on the DSPs. The NMC is running 5.6.2. This is a new chassis. Samuel S. Lowe Director, Data Services UniversalCom, Inc. slowe@universalcom.net - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message. - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.